VI. Line Geometry as a Study of a Manifoldness of Constant Curvature

A Comparative Review of Recent Researches in Geometry — Note VI (Trans. M. W. Haskell, 1893, pp. 242–249)

In combining line geometry with the projective measurement in a manifoldness of five dimensions, we must remember that the straight lines represent elements of the manifoldness which, metrically speaking, are at infinity. It then becomes necessary to consider what the value of a system of a projective measurement is for the elements at infinity; and this may here be set forth somewhat at length, in order to remove any difficulties which might else seem to stand in the way of conceiving of line geometry as a metrical geometry. We shall illustrate these expositions by the graphic example of the projective measurement based on a quadric surface.

Any two points in space have with respect to the surface an absolute invariant, — the anharmonic ratio of the two points together with the two points of intersection of the line joining them with the surface. But when the two points move up to the surface, this anharmonic ratio becomes zero independently of the position of the points, except in the case where the two points fall upon a generator, when it becomes indeterminate. This is the only special case which can occur in their relative position unless they coincide, and we have therefore the theorem:

The projective measurement in space based upon a quadric surface does not yet furnish a measurement for the geometry on the surface.

This is connected with the fact that by linear transformations of the surface into itself any three points of the surface can be brought into coincidence with three others [1].

If a measurement on the surface itself be desired, we must limit the group of transformations, and this result is obtained by supposing any arbitrary point of space (or its polar plane) to be fixed. Let us first take a point not on the surface. We can then project the surface from the point upon a plane, when a conic will appear as the boundary curve. Upon this conic we can base a projective measurement in the plane, which must then be transferred back to the surface [2]. This is a measurement with constant curvature in the true sense, and we have then the theorem:

Such a measurement on the surface is obtained by keeping fixed a point not on the surface.

Correspondingly, we find [3]:

A measurement with zero curvature on the surface is obtained by choosing as the fixed point a point of the surface itself.

In all these measurements on the surface the generators of the surface are lines of zero length. The expression for the element of arc on the surface differs therefore only by a factor in the different cases. There is no absolute element of arc upon the surface; but we can of course speak of the angle formed by two directions on the surface.

All these theorems and considerations can now be applied immediately to line geometry. Line-space itself admits at the outset no measurement, properly speaking. A measurement is only obtained by regarding a linear complex as fixed; and the measurement is of constant or zero curvature, according as the complex is a general or a special one (a line). The selection of a particular complex carries with it further the acceptation of an absolute element of arc. Independently of this, the directions to adjoining lines cutting the given line are of zero length, and we can besides speak of the angle between any two directions (Math. Ann. 5, 1872, 257–277).


Footnotes (1893 Edition)